What is the difference between 1756 enbt and 1756 en2t

Thread Tools. February 14th, , PM. Find More Posts by sayahan Find More Posts by seth Thanks a lot Seth. Greatly appreciated. February 15th, , AM. Find More Posts by tarik March 28th, , PM. Find More Posts by Phrog March 29th, , AM. Find More Posts by Geospark.

March 29th, , PM. Quote: Originally posted by Geospark : Or, indeed, if designing a new system, then the latest ControlLogix with embedded and enhanced Ethernet port should also be given careful consideration.

Find More Posts by kamenges. Find More Posts by rupej. Quote: Originally posted by rupej : Sounds like you're either getting a crazy good deal on L7x and EN2T, or you're getting screwed on L8x.

Twitter Reddit Digg del. Posting Rules. Similar Topics. December 8th, AM. EN2T Connection Failure. October 2nd, PM. Communication between 2 en2t mounted on same control logix chassis. Have A Question? Encoders Sensors. Author Recent Posts. Shawn Tierney. Shawn began programming as a pre-teen in the early 80's, and after earning a degree in Electronics he worked as an Automation Specialist for 25 years. Latest posts by Shawn Tierney see all.

Hope this helps, Shawn Tierney Have a question or comment on this article? Thanks for the heads up Kell! Sign in. Forgot your password? Get help. Create an account. Note that in our case video , multiple adapters are shown due to Virtual Machines being installed on the laptop used.

This may be confusing for many users. At this point, the new driver should have been added to RSLinx. By connecting over USB on newer cards, the user may skip the steps above and set an IP address directly. Once the connection is established, the user can go into the properties of the device or the other modules within the chassis and set the required parameters. The most important step in getting started with PLC is communication with the device.

Within the ControlLogix family, the most common means to connect at the ENxx modules. This can be accomplished through the use of the dip switches on the card. A rather simple alternative to the steps above would be to use a USB connection to the cards that support it.